2000w halogen heating lamp 740mm sk15 infrared lamp for printing drying

May 6, 2026

2000W Halogen Infrared Lamp: The Heat Behind the Print

We built this 2000W halogen lamp for one reason: industrial drying that needs serious punch in a tight space. Where every inch counts and timing is everything, this lamp brings the heat—fast. The 740mm length and SK15 base aren’t random. They were chosen on purpose to give you a compact, high-intensity heat source that slips right into your existing printing and coating lines without a fight.

Power, Size, and a Clean Fit

Here’s the thing about packing 2000W into a 740mm tube: you get intense heat, quickly. It’s all about focused energy, not warming up the whole room. Think of it as a precision tool for the exact spot you need to dry. And that SK15 connector? It’s a simple bi-pin design that locks in clean and tight. That means fewer hot spots, a lamp that stays put, and when it’s time for a replacement, you can swap it out fast—no fuss, no downtime.

The Secret: Halogen and Infrared

Inside, the halogen cycle is doing the heavy lifting. It keeps the filament burning bright without the light dimming over time. The quartz envelope then pushes most of that energy out as short-wave infrared. That infrared doesn’t just sit on top of the wet ink—it dives in. It heats from the inside out, which is why you get quick drying without scorching the surface. It just works.

Why It Shines in Printing Drying

On a printing line, you need heat that jumps into action the second you flip the switch. This lamp hits temperature almost instantly, so you can get your line back up to speed without a slow, painful startup. The 740mm length is just right for covering the drying zone, and with the SK15 base, it’s a straightforward drop-in. No re-engineering, no headaches. But there’s a trade-off. That much power in one spot means you’ve got to manage the heat. You’ll need proper airflow and a good reflector design, especially in a tight enclosure, to keep everything—the lamp and the electronics—cool and safe. We built this for engineers who want a heat source that’s predictable, easy to wire up, and tough enough for the daily grind of a production floor. One quick note: the spec mentions an SK15 base, but the industry standard for this lamp family is usually R7s. If you need the R7s version, we’ve got you covered—same 2000W halogen infrared tube, just the right fit.